Key Elements:

• All American steel - no foreign product of questionable quality.

• MADE IN THE USA!

• Back of the bucket has a 6" roll - no bends. Material is less likely to gum up in the back of the bucket.

• 4" wide step/walk along the entire top of the bucket.

• No bolt holes in the cutting bar. Holes weaken the cutting bar. Teeth can be welded on, or you can add a tooth bar.

• Extra 6" x 3/4" cross brace under the front of the bucket. The front edge of most buckets bows down over time. This helps keep it straight. Its hard to do nice grading with a bent bucket!

• Skid plates on the bottom of the bucket are 4" wide and 3/4" thick.

• Bucket end caps are 3/8" thick.

• All bracing running the length of the bucket is 3/8" thick.

• Bucket end cap leading edges are finished with a 3/8" cutting edge. This is part of the digging edge of the bucket. It baffles us why most manufacturers use a blunt piece of steel. You sure wouldn't do that on the front edge - why would you do it on the side? Because its cheaper! Well, do you want a good bucket?

Dimensions & Weight:

• 84" wide

• 22" high

• 900 pounds total weight

Requires installation of the 3D viewer from SolidWorks. When asked if you want to install the "eDrawings Add-on from Dassault Systems SolidWorks Corp" please choose YES and INSTALL.